Rohde & Schwarz SGS100A - TEST Subsystem

Remote Control Commands
R&S
®
SGS100A
278User Manual 1173.9105.02 ─ 12
Example:
SYSTem:OSYStem?
Response: "Linux"
Usage: Query only
11.22 TEST Subsystem
The TEST system contains the commands for performing the routines as well as for
direct manipulation of the hardware assemblies (:TEST:DIRect).
The self tests return a "0" if the test is performed successfully, otherwise a value other
than "0" is returned. None of the commands of this system have an *RST value.
Improper use can destroy the assembly
The respective hardware assembly responds directly to the :TEST:DIRect command;
any safety mechanisms are bypassed. The command is intended for servicing purpo-
ses and should be used only by the Rohde & Schwarz service personnel.
:TEST:ALL:STARt...........................................................................................................278
:TEST:ALL:RESult?........................................................................................................278
:TEST:KEYBoard[:STATe]............................................................................................... 278
:TEST:ALL:STARt
Starts the selftest. Use the command :TEST:ALL:RESult? to query the result.
Example:
See Chapter 11.1.1, "Performing General Task for Instrument
Setup", on page 191.
Usage: Event
:TEST:ALL:RESult?
Queries the result of the performed selftest. Start the selftest with :TEST:ALL:STARt.
Return values:
<Result> 0 | 1 | RUNning | STOPped
*RST: STOPped
Example: See Chapter 11.1.1, "Performing General Task for Instrument
Setup", on page 191.
Usage: Query only
:TEST:KEYBoard[:STATe] <State>
Enable/disable keyboard and LED test state.
TEST Subsystem