Instrument Tour
R&S
®
SGS100A
34User Manual 1173.9105.02 ─ 12
●
If the interface is configured as a host interface, a memory stick for file transmis-
sion can be connected.
For details, see Chapter 2.3.4, "Connecting a Controller or a USB Device via USB",
on page 28.
[LAN Connector]
The [LAN] (Ethernet) interface allows you to connect the R&S SGS to other devices
like a remote computer. On the computer, you can perform a firmware update, manual
operation via the R&S SGMA-GUI software or for remote control of the instrument. The
connection to the remote computer can be direct or via a network.
For details, see Chapter 2.3.2, "Connecting a Remote PC via LAN", on page 24.
[RF OUT]
Provides an RF 50 Ohm signal output.
NOTICE! Maximum input levels. Do not overload the RF output. The maximum permis-
sible back-feed is specified in the data sheet.
[I , Q]
SMA female type connectors that are inputs of the I/Q modulator, provided for feeding
of external signal.
NOTICE! Maximum input levels. Do not overload the I and Q inputs. The maximum
permissible voltage is 1V. For details, refer to the data sheet.
Note: The I/Q modulator requires one of the hardware options R&S SGS-B106V/-
B112V.
[REF / LO IN, REF / LO OUT]
Rear Panel Tour
To Next Page
Loading...
