System Overview
R&S
®
SGS100A
43User Manual 1173.9105.02 ─ 12
For a direct PCIe connection, an automatic identification of the R&S SGU as an exten-
sion is only available for an R&S SGS with a "Controller > Revision" 5 or higher. For a
description on how to manually set the PCIe identification, see Chapter 9.14, "How to
Manually Set a PCIe Direct Connection between an R&S SGS and an R&S SGU",
on page 161.
You can check the "Controller > Revision" of your instrument in the "SGMA-GUI >
Instrument Name > Hardware Config" dialog.
If instrument is not automatically added as an extension
If the R&S SGU is not automatically added as an extension you can do that manually
in the "SGMA-GUI > R&S SGS Name > Extension" dialog.
If the R&S SGU is not listed in the list of "Available Instruments", you can press "Scan
> Start" to find the instrument.
5.2.2 Connection in a Company Network
Connection of an R&S SGS and an R&S SGU in a Company Network
As a prerequisite for this example the R&S SGMA-GUI software has to be installed on
a remote PC.
Setups for Connecting an R&S SGS and an R&S SGU
To Next Page
Loading...
