Understanding the R&S SGMA-GUI Software
R&S
®
SGS100A
66User Manual 1173.9105.02 ─ 12
Instrument Name/ IP Address
Displays the alias name of the instrument and the IP address, as set by the parameters
in "SGMA-GUI > Setup > Instruments > Add/Edit Instruments" dialog.
Click the button to access a menu tree for configuring the available instrument's set-
tings, e.g. "Level" settings.
Freq/Freq (Offs)
Sets the RF frequency, incl. enabled frequency offset.
The following apples:
"Freq" = Frequency + Offset
Where, the value set with the parameter "SGMA-GUI main panel > instrument name >
Frequency/Phase > Frequency" is the RF frequency at the RF output, without the fre-
quency offset.
The icon "Freq (Offs)" indicates that a frequency offset is applied.
Remote command:
[:SOURce]:FREQuency[:CW|FIXed] on page 236
RF On/Off
Activates and deactivates the RF output signal.
The current state of the RF output (activated and deactivated) is indicated in the main
panel with the different block color (blue or gray) and the status "On/Off".
Remote command:
:OUTPut[:STATe] on page 223
Mod State
Switches the I/Q modulation on and off.
Remote command:
[:SOURce]:IQ:STATe on page 246
PEP
Displays the Peak Envelope Power (PEP) of the RF signal of the selected instrument.
The value is calculated as follows:
"PEP" = Level + Crest Factor
Remote command:
[:SOURce]:POWer:PEP? on page 252
Level/Level Offset
Sets the RF level at the RF output connector of the selected instrument.
If you set a level offset, it will be indicated in the R&S SGMA-GUI main panel by a
change in the name of this parameter from "Level" to "Level Offset".
Main Panel
To Next Page
Loading...