Understanding the R&S SGMA-GUI Software
R&S
®
SGS100A
72User Manual 1173.9105.02 ─ 12
Field "Edit Instrument > Symbolic Name" displays the name of the instrument as
shown in the R&S SGMA-GUI main panel.
Dialog "Edit Instrument" does not appear
If this dialog does not open, perform the following:
●
Check whether the instrument is correctly connected to the external PC on which
you work with the R&S SGMA-GUI.
●
Check if the instrument is configured in the R&S SGMA-GUI and perform, if neces-
sary, the steps described in Chapter 6.4.2, "Handling Instruments in the R&S
SGMA-GUI", on page 68.
●
Select "SGMA-GUI > Setup > Instruments", check the state of the instrument in the
"Configure Instruments > Available Instruments" table and activate it, if disabled.
Working with R&S SGMA-GUI
To Next Page
Loading...