Rohde & Schwarz SGS100A - Instruments:mapping:file; Instruments:name; Instruments:remote:channel; Instruments:remote:name

Understanding the R&S SGMA-GUI Software
R&S
®
SGS100A
77User Manual 1173.9105.02 ─ 12
:INSTruments:MAPPing:FILE <File>
Saves the list of the available instruments in a mapping file. Mapping files are stored
with the predefined file extension .map; the file extension may be omitted.
The file is saved in the default directory. Use the command MMEM:CDIRectory to
change the default directory or specify the complete path.
Parameters:
<File> string
Example: See Chapter 6.5.1, "Configuring Instruments in the R&S SGMA-
GUI", on page 74.
Manual operation: See "Export" on page 56
:INSTruments:NAME <Name>
Selects the alias name of the instruments, i.e. sets the "Symbolic Name".
Parameters:
<Name> <SymbolicNameInstr#1>,<SymbolicNameInstr#2>,...
Example: See Chapter 6.5.1, "Configuring Instruments in the R&S SGMA-
GUI", on page 74.
Manual operation: See "Available Instruments" on page 55
:INSTruments:REMote:CHANnel <Channel>
Sets the hardware interface used by the remote channel.
Parameters:
<Channel> List of CHAR-Data
<Channellnstr#1>,<Channellnstr#2>,...
The available interfaces are: LAN, USB, SOCKET, PCIe, GPIB,
HiSLIP
Example: See Chapter 6.5.1, "Configuring Instruments in the R&S SGMA-
GUI", on page 74.
Manual operation: See "Hardware Channel" on page 58
:INSTruments:REMote:NAME <Name>
Enters the IP Address or the host name of the connected instrument.
Parameters:
<Name> <Hostname/IP-AddressInsr#1>,<Hostname/IP-Addres-
sInsr#2>,...
Example: See Chapter 6.5.1, "Configuring Instruments in the R&S SGMA-
GUI", on page 74.
Manual operation: See "Instrument Name / IP Address" on page 58
Remote Control of the R&S SGMA-GUI