Rohde & Schwarz SGS100A - Instruments:gpib:address

Understanding the R&S SGMA-GUI Software
R&S
®
SGS100A
78User Manual 1173.9105.02 ─ 12
:INSTruments:GPIB:ADDRess <Serial>
Sets the GPIB Address of the connected instrument.
Parameters:
<Serial> List of Numbers
Manual operation: See "GPIB Address" on page 59
:INSTruments:GPIB:BOARd <Board>
Identifies the GPIB bus card the controller uses.
Parameters:
<Board> List of Numbers
Manual operation: See "Board Number" on page 59
:INSTruments:SCAN <State>
Triggers a scan function and searches for instruments connected to the remote com-
puter via all of the available interfaces.
Parameters:
<State> number
1 = triggers the scan function, 0 = aborts the running scan proc-
ess
The query command returns 1 as long as scan is running; 0 indi-
cates completed scan process.
Example: See Chapter 6.5.1, "Configuring Instruments in the R&S SGMA-
GUI", on page 74.
Manual operation: See "Scan" on page 55
:INSTruments:SCAN:HNPRefix <Prefix>
Sets the prefix the searched host names begin with.
Parameters:
<Prefix> string
Example: See Chapter 6.5.1, "Configuring Instruments in the R&S SGMA-
GUI", on page 74.
Manual operation: See "Scan LAN instruments with host name prefix" on page 57
:INSTruments:SERial <Serial>
Enters the serial number as instrument's identification while using the USB interface for
remote control.
Remote Control of the R&S SGMA-GUI