Rohde & Schwarz SGS100A - Page 9

Contents
R&S
®
SGS100A
7User Manual 1173.9105.02 ─ 12
8.14 Diagnostic and Tests................................................................................................ 144
8.14.1 Self-test....................................................................................................................... 145
8.14.2 Keyboard Tests........................................................................................................... 145
8.15 External Adjustments............................................................................................... 146
9 Performing Configuration Tasks...................................................... 147
9.1 How to Generate an I/Q Modulated Signal..............................................................147
9.2 How to Generate I/Q Signals with an R&S SGS and an R&S SGU Upconverter. 149
9.3 How to Enable a Baseband Bypass Mode.............................................................. 151
9.4 How to Configure the Reference Oscillator Source...............................................152
9.5 How to Configure the Local Oscillator (LO) Coupling Source..............................153
9.6 How to Define the Signal at the REF/LO OUT Connector......................................154
9.7 How to Connect and Configure Instruments for Optimum Phase Coherence.... 154
9.8 How to Restore the LAN Connection to an Instrument......................................... 155
9.9 How to Switch between the Operating States........................................................ 156
9.10 How to Use Computer Names..................................................................................158
9.11 How to Optimize Performance................................................................................. 158
9.12 How to Install a New Firmware Version on the Instrument................................... 159
9.13 How to Activate Options...........................................................................................161
9.14 How to Manually Set a PCIe Direct Connection between an R&S SGS and an R&S
SGU............................................................................................................................ 161
10 Network and Remote Control Operation..........................................162
10.1 Remote Control Interfaces and Protocols.............................................................. 162
10.1.1 Remote Control Programs and Libraries.....................................................................163
10.1.2 LAN Interface.............................................................................................................. 165
10.1.2.1 VISA Resource Strings............................................................................................... 166
10.1.2.2 HiSLIP Protocol...........................................................................................................167
10.1.2.3 VXI-11 Protocol........................................................................................................... 168
10.1.2.4 Socket Communication............................................................................................... 168
10.1.3 USB Interface..............................................................................................................168
10.1.4 PCI Express Interface................................................................................................. 169
10.1.5 GPIB Interface (IEC/IEEE Bus Interface)....................................................................170
10.2 Starting a Remote Control Session.........................................................................170
10.2.1 How to Find the VISA Resource String....................................................................... 171