Signal Generator Settings
R&S
®
SGS100A
92User Manual 1173.9105.02 ─ 12
7.5.3 Power-On/EMF
► To access the power- on/EMF settings, select "SGMA-GUI > Instrument Name >
Level > Power-On/EMF".
This dialog comprises the settings for the power-on behavior of the instrument.
Power-On State
Selects the state which the RF output takes after the instrument is switched on.
"RF Off"
The output is deactivated when the instrument is switched on.
"Previous Setting"
When the instrument is switched on, the output takes the same state
as it had when the instrument was switched off.
Remote command:
:OUTPut[:STATe]:PON on page 223
7.5.4 ALC
► To access the automatic level control (ALC) settings, select "SGMA-GUI > Instru-
ment Name > Level > ALC".
Automatic level control can be used with almost all applications, especially I/Q
modulation. It only has to be deactivated for certain settings in the baseband and
when I/Q impairments ("Impairments State On") are activated. This is indicated
under the respective function.
Level and Power-On Settings
To Next Page
Loading...
