Instrument tour
R&S
®
SMA100B
42Getting Started 1419.8620.02 ─ 10
LF
BNC connector for output of the internal LF generator signal.
See the data sheet and in the user manual, section "Analog modulation".
Ext 1/2
BNC connectors for input of external analog modulation signals.
AC power supply connector and switch
Mains power switch for performing the following tasks:
●
Connecting the internal power supply to the power source
●
Disconnecting the internal power supply from the power source
How to: Chapter 4.6, "Connecting to power", on page 22.
RF 50 Ω
Rear panel connector for the RF signal. This connector is for use of the instru-
ment in a 19" rack.
How to:
●
Chapter 4.4.2, "Mounting the R&S SMA100B in a rack", on page 20
●
Chapter 4.10, "Connecting to RF 50 Ω", on page 26
Rear panel tour
To Next Page
Loading...
