Avionic Standards
R&S
®
SMA100B
135User Manual 1178.3834.02 ─ 05
2. Select "ILS > General".
This dialog comprises carrier frequency settings related to the ILS localizer compo-
nent of the ILS signal.
Settings
Carrier Frequency Mode............................................................................................. 135
Carrier Frequency....................................................................................................... 135
ICAO Channel.............................................................................................................136
Sync with Glide Slope/ Sync with Localizer................................................................ 136
EXT AM.......................................................................................................................136
Carrier Frequency Mode
Sets the mode for the carrier frequency of the signal.
"User Defined"
Activates user-defined variation of the carrier frequency.
"ICAO"
Activates variation in predefined steps according to standard ILS
transmitting frequencies (see Table 5-2).
Select the ICAO Channel to set a standard ILS frequency channel. If
you want to couple carrier frequencies of ILS glide slope and localizer
components, enable General Settings .
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:FREQuency:MODE on page 566
Carrier Frequency
Requires "Carrier Frequency Mode > User Defined".
Sets the carrier frequency of the signal.
Remote command:
[:SOURce<hw>]:ILS:LOCalizer:FREQuency on page 565
ILS Configuration and Settings
To Next Page
Loading...
