Rohde & Schwarz SMAB-B92 - Page 204

Improving Level Performance
R&S
®
SMA100B
202User Manual 1178.3834.02 ─ 05
b) Proceed with step 4.
3. If you need to create a file:
a) Select "UCOR Data > New".
b) Enter the filename UCOR_Data and confirm with "Ok".
c) Choose the file and confirm with "Select".
d) Select "Edit UCOR Data".
e) To fill the user correction data table, proceed as described in Chapter 6.7, "List
Editor", on page 188.
4. Select "RF Level > RF State > On".
5. Select "User Cor. Data > State > On".
The "UCOR" dialog contains all settings for creating and handling files with user-
defined level correction values.
The remote commands required to define these settings are described in Chap-
ter 13.16.3, "SOURce:CORRection Subsystem", on page 582.
Settings
State............................................................................................................................202
User Correction...........................................................................................................202
UCOR Data.................................................................................................................203
Edit UCOR Data..........................................................................................................203
State
Activates user correction.
The R&S SMA100B displays the status icon "Lev Ucor" in the "Level" panel.
Remote command:
[:SOURce<hw>]:CORRection[:STATe] on page 587
User Correction
Indicates the corrected level value for a specific frequency point.
User Correction