Rohde & Schwarz SMAB-B92 - Page 274

Reference Oscillator
R&S
®
SMA100B
272User Manual 1178.3834.02 ─ 05
In the "Reference Frequency" tab, you can select the signal source of the reference
frequency and define the frequency of an external reference signal.
2. Observe the information on the home screen, "Frequency" tile.
The "Frequency" tile indicates the current reference oscillator configuration, incl.
the reference oscillator source, external reference frequency (rounded value) and
output connector. A warning symbol in the "Frequency" tile indicates a missing
external source.
The remote commands required to define these settings are described in Chap-
ter 13.16.12, "SOURce:ROSCillator Subsystem", on page 637.
Settings:
Set to Default.............................................................................................................. 273
Source.........................................................................................................................273
Show Connector..........................................................................................................273
Deactivate RF Output (if external reference is missing)..............................................273
External Reference Frequency................................................................................... 273
Reference Frequency Settings