General Instrument Functions
R&S
®
SMA100B
337User Manual 1178.3834.02 ─ 05
If the instrument is subject to high security, and you have not enabled the volatile
mode, the internal flash memory holds user-data, i.e. id poses a security risk. The sani-
tizing function makes sure that no user information is stored on the instrument when it
leaves the secure environment.
To apply the change: enter the security password and confirm with "Accept". Otherwise
the change has no effect.
See also Chapter 11.4, "Using the Security Settings", on page 332 for more information
on the security concept.
Remote command:
:SYSTem:SECurity:SANitize[:STATe] on page 670
11.4.2.3 Manual Operation Security Settings
Access:
► Select "System Config > Setup > Security > Security > General > Manual Opera-
tion".
The "SW Update" tab enables you to lock front panel operation and/or reading the
display.
The remote commands available to control security settings are described in Chap-
ter 13.9, "DISPlay Subsystem", on page 432, and the Chapter 13.17, "SYSTem Sub-
system", on page 653.
Annotation Frequency
Enables the display of the currently used frequency in the status bar.
To apply the change: enter the security password and confirm with "Accept". Otherwise
the change has no effect.
Remote command:
:DISPlay:ANNotation:FREQuency on page 435
Annotation Amplitude
Enables the display of the currently selected level in the status bar.
Using the Security Settings
To Next Page
Loading...
