Rohde & Schwarz SMAB-B92 - Page 428

Remote Control Commands
R&S
®
SMA100B
426User Manual 1178.3834.02 ─ 05
:CSYNthesis:STATe........................................................................................................426
:CSYNthesis:OTYPe...................................................................................................... 426
:CSYNthesis:FREQuency............................................................................................... 426
:CSYNthesis:POWer...................................................................................................... 427
:CSYNthesis:OFFSet:STATe............................................................................................427
:CSYNthesis:OFFSet......................................................................................................427
:CSYNthesis:VOLTage....................................................................................................428
:CSYNthesis:PHASe...................................................................................................... 428
:CSYNthesis:PHASe:REFerence..................................................................................... 428
:CSYNthesis:POWer:STEP:MODE.................................................................................. 429
:CSYNthesis:FREQuency:STEP:MODE........................................................................... 429
:CSYNthesis:POWer:STEP[:INCRement]......................................................................... 429
:CSYNthesis:FREQuency:STEP......................................................................................429
:CSYNthesis:STATe <State>
Activates the clock synthesis.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Chapter 13.7, "CSYNthesis Subsystem", on page 425.
Manual operation: See " State " on page 279
:CSYNthesis:OTYPe <Mode>
Defines the shape of the generated clock signal.
Parameters:
<Mode> SESine | DSQuare | CMOS | DSINe
SESine = single-ended sine
DSINe = differential sine
DSQuare = differential square
CMOS = CMOS
*RST: SESine
Example: See Chapter 13.7, "CSYNthesis Subsystem", on page 425.
Manual operation: See "Output Type" on page 279
:CSYNthesis:FREQuency <Frequency>
Sets the frequency of the generated clock signal.
Parameters:
<Frequency> float
Numerical value
Sets the frequency
CSYNthesis Subsystem