Rohde & Schwarz SMAB-B92 - Page 475

Remote Control Commands
R&S
®
SMA100B
473User Manual 1178.3834.02 ─ 05
Parameters:
<Separator> TABulator | SEMicolon | COMMa | BLANk
*RST: COMMa
Example:
SENS:SWE:HCOP:DEV:LANG CSV
Selects output format *.csv.
SENS:SWE:HCOP:DEV:LANG:CSV:SEP TAB
A tab separates the values.
Manual operation: See "Separator" on page 259
:SENSe[:POWer]:SWEep:HCOPy:DEVice:SIZE <Size>
Sets the size of the hardcopy in number of pixels. The first value of the size setting
defines the width, the second value the height of the image.
Parameters:
<Size> 320,240 | 640,480 | 800,600 | 1024,768
*RST: 320,240
Example:
SENS:SWE:HCOP:DEV:LANG BMP
Selects output format *.bmp.
SENS:SWE:HCOP:DEV:SIZE 320,240
The size of the bitmap is 320 pixels by 240 pixels.
:SENSe[:POWer]:SWEep:HCOPy:FILE[:NAME] <Name>
Creates of selects a file for storing the hardcopy after the :SENSe[:POWer]:SWEep:
HCOPy[:EXECute] on page 478 command is sent. The directory is either defined
with the command MMEMory:CDIR or the path is specified together with the file name.
Access to the file via remote control is possible using the commands of the MMEM-
Subsystem. In contrast, command :SENSe[:POWer]:SWEep:HCOPy:DATA?
on page 470 transfers the hardcopy contents directly to the remote client where they
can be further processed.
Parameters:
<Name> string
Example:
SENS:SWE:HCOP:DEV:LANG BMP
Selects output format *,bmp.
SENS:SWE:HCOP:FILE:AUTO:STAT OFF
Switches off automatic naming.
SENS:SWE:HCOP:FILE 'var/trace/nrp_trace1'
creates the file nrp_trace1.bmp in the trace directory.
SENS:SWE:HCOP:EXEC
Triggers the generation of a hardcopy of the current trace. The
hardcopy is stored in the file nrp_trace1.bmp.
Manual operation: See " File name - Power Analysis " on page 254
Power Sensor Measurement Subsystems