Remote Control Commands
R&S
®
SMA100B
494User Manual 1178.3834.02 ─ 05
Example:
TRAC:SWE:MEAS:TRAC2:PULS:PER:DISP:ANN ON
Selects the pulse period to be indicated in the display.
TRAC:SWE:MEAS:PULS:DISP:ANN ON
Activates indication of the selected pulse data in the display.
Options: Option R&S SMAB-K28
Manual operation: See "Overshoot (Rising Edge / Falling Edge)" on page 247
:TRACe<ch>[:POWer]:SWEep:MEASurement:PULSe:ALL:DISPlay:ANNotation[:
STATe] <State>
This command deactivates the indication of all pulse data of the selected trace. The
parameters to be indicated can be selected with the TRAC:SWE:MEAS:…. commands.
Only six parameters are indicated at one time.
Note: This command is only available in time measurement mode and with R&S
NRPZ81 power sensors.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
TRAC:SWE:MEAS:PULS:ALL:DISP:ANN OFF
Switches the indication of all pulse data off.
Options: Option R&S SMAB-K28
:TRACe<ch>[:POWer]:SWEep:PULSe:THReshold:BASE?
Queries how the threshold parameters are calculated.
Note: This parameter is only avalaible in time measurement mode and R&S NRP-Z81
power sensors.
Return values:
<Base> VOLTage | POWer
*RST: VOLTage
Example:
TRAC1:SWE:PULS:THR:BAS?
Queries the threshold base of pulse data calculation.
Usage: Query only
Manual operation: See " Base - Pulse Data Analysis " on page 243
:TRACe<ch>[:POWer]:SWEep:PULSe:THReshold:POWer:HREFerence
<HReference>
Queries the upper threshold level of the overall pulse level. The distal power defines
the end of the rising edge and the start of the falling edge of the pulse.
Note: This parameter is only avalaible in time measurement mode and R&S NRP-Z81
power sensors.
Power Sensor Measurement Subsystems
To Next Page
Loading...
