Rohde & Schwarz SMAB-B92 - Page 517

Remote Control Commands
R&S
®
SMA100B
515User Manual 1178.3834.02 ─ 05
// Activating the external exponential AM changes the coupling
// in this example for EXT2
INPut:MODext:COUPling2 DC
// Configure the modulation settings
// Switch on AM and RF signal output
SOURce1:AM1:STATe 1
OUTPut1:STATe 1
The following commands are available:
[:SOURce<hw>]:AM<ch>:STATe......................................................................................515
[:SOURce<hw>]:AM<ch>:SOURce.................................................................................. 515
[:SOURce<hw>]:AM<ch>[:DEPTh]...................................................................................516
[:SOURce<hw>]:AM<ch>:DEPTh:LINear..........................................................................516
[:SOURce<hw>]:AM<ch>:DEPTh:EXPonential..................................................................517
[:SOURce<hw>]:AM:MODE............................................................................................ 517
[:SOURce<hw>]:AM:DEPTh:SUM....................................................................................517
[:SOURce<hw>]:AM:DEViation:MODE............................................................................. 518
[:SOURce<hw>]:AM:RATio..............................................................................................518
[:SOURce<hw>]:AM<ch>:SENSitivity:EXPonential............................................................ 518
[:SOURce<hw>]:AM<ch>:SENSitivity[:LINear]...................................................................519
[:SOURce<hw>]:AM:TYPE..............................................................................................519
[:SOURce<hw>]:AM<ch>:STATe <State>
Activates amplitude modulation.
Suffix:
<ch>
.
1 to 2
Modulation signal channel
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Creating an amplitude modulated RF signal"
on page 513.
Manual operation: See "State" on page 79
[:SOURce<hw>]:AM<ch>:SOURce <Source>
Selects the modulation source for amplitude modulation.
Suffix:
<ch>
.
1 to 2
Modulation signal channel
Parameters:
<Source> LF1 | LF2 | NOISe | EXT1 | EXT2 | EXTernal | INTernal
SOURce Subsystem