Rohde & Schwarz SMAB-B92 - Page 549

Remote Control Commands
R&S
®
SMA100B
547User Manual 1178.3834.02 ─ 05
Parameters:
<Filename> "<filename>"
Filename or complete file path; file extension can be omitted
Example: See Example "Save/Recall a configuration" on page 541.
Usage: Setting only
<subsystem>:SETTing:STATe
[:SOURce<hw>]:ADF:STATe <State>
[:SOURce<hw>]:ILS:STATe <State>
[:SOURce<hw>]:VOR:STATe <State>
Activates/deactivates the VOR modulation.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Save/Recall a configuration" on page 541.
<subsystem>:SETTing:STORe
[:SOURce<hw>]:ADF:SETTing:STORe <Filename>
[:SOURce<hw>]:ILS:SETTing:STORe <Filename>
[:SOURce<hw>]:VOR:SETTing:STORe <Filename>
Saves the current settings into the selected file; the file extension
(*.adf/*.ils/*.vor) is assigned automatically.
Parameters:
<Filename> "<filename>"
Filename or complete file path
Example: See Example "Save/Recall a configuration" on page 541.
Usage: Setting only
<subsystem>:SETTing:SOURce
[:SOURce<hw>]:ILS[:GS|GSLope]:SOURce <IlsGsSource>
[:SOURce<hw>]:ILS:LOCalizer:SOURce <IlsLocSource>
[:SOURce<hw>]:VOR:SOURce <VorSourceSel>
Sets the modulation source for the avionic standard modulation.
If external modulation source is set, the external signal is added to the internal signal.
Switching off the internal modulation source is not possible.
Parameters:
<VorSourceSel> INT | INT,EXT | EXT
INT
Internal modulation source is used.
SOURce Subsystem