Rohde & Schwarz SMAB-B92 - Page 555

Remote Control Commands
R&S
®
SMA100B
553User Manual 1178.3834.02 ─ 05
[:SOURce<hw>]:ILS:LOCalizer:SOURce.......................................................................... 569
[:SOURce<hw>][:ILS]:MBEacon:COMid:CODE................................................................. 569
[:SOURce<hw>][:ILS]:MBEacon:COMid:DASH................................................................. 569
[:SOURce<hw>][:ILS]:MBEacon:COMid:DEPTh................................................................570
[:SOURce<hw>][:ILS]:MBEacon:COMid:DOT....................................................................570
[:SOURce<hw>][:ILS]:MBEacon:COMid:FREQuency.........................................................570
[:SOURce<hw>][:ILS]:MBEacon:COMid:LETTer................................................................ 571
[:SOURce<hw>][:ILS]:MBEacon:COMid:PERiod............................................................... 571
[:SOURce<hw>][:ILS]:MBEacon:COMid:SYMBol...............................................................571
[:SOURce<hw>][:ILS]:MBEacon:COMid:TSCHema........................................................... 572
[:SOURce<hw>][:ILS]:MBEacon:COMid[:STATe]............................................................... 572
[:SOURce<hw>][:ILS]:MBEacon:FREQuency....................................................................572
[:SOURce<hw>][:ILS]:MBEacon:FREQuency:MODE......................................................... 572
[:SOURce<hw>][:ILS]:MBEacon:MARKer:FREQuency.......................................................573
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:DEPTh............................................................ 573
[:SOURce<hw>][:ILS]:MBEacon:PRESet..........................................................................573
[:SOURce<hw>][:ILS]:MBEacon[:MARKer]:PULSed.......................................................... 573
[:SOURce<hw>]:ILS:TYPE <Type>
Selects the ILS modulation type.
Parameters:
<Type> GS | LOCalize | GSLope | MBEacon
*RST: GS
Example: See Example "Configure and generate an ILS glide slope signal"
on page 542.
Manual operation: See "ILS Component" on page 126
[:SOURce<hw>]:ILS[:GS|GSLope]:DDM:COUPling <Coupling>
Selects if the DDM value is fixed or is changed with a change of sum of modulation
depths (SDM, see [:SOURce<hw>]:ILS[:GS|GSLope]:SDM on page 559).
Parameters:
<Coupling> FIXed | SDM
*RST: FIXed
Example: See Example "Configure and generate an ILS glide slope signal"
on page 542.
Manual operation: See "DDM - SDM Coupling" on page 134
[:SOURce<hw>]:ILS[:GS|GSLope]:DDM:CURRent <Current>
Sets the DDM value alternatively as a current by means of the ILS indicating instru-
ment. The instrument current is calculated according to:
DDM Current µA = DDM Depth [%] × 857,125 µA
SOURce Subsystem