Remote Control Commands
R&S
®
SMA100B
579User Manual 1178.3834.02 ─ 05
Manual operation: See "COM/ID State" on page 122
[:SOURce<hw>]:VOR:FREQuency <CarrierFreq>
Sets the carrier frequency of the signal.
Parameters:
<CarrierFreq> float
Range: 100E3 to 6E9
Increment: 0.01
*RST: 108E6
Example: See Example "Configure and generate a VOR signal"
on page 544.
Manual operation: See "Carrier Frequency" on page 118
[:SOURce<hw>]:VOR:FREQuency:MODE
<Mode>
Sets the mode for the carrier frequency of the signal.
Parameters:
<Mode> USER | ICAO
*RST: USER
Example: See Example "Configure and generate a VOR signal"
on page 544.
Manual operation: See "Carrier Frequency Mode" on page 118
[:SOURce<hw>]:VOR:ICAO:CHANnel <Channel>
Sets the ICAO channel and the corresponding transmitting frequency.
If avionic standard modulation is activated and you change the "RF Frequency", the
frequency value of the closest ICAO channel is applied automatically. The "ICAO
Channel" is also updated.
The carrier frequency is set automatically to the value of the ICAO channel. For an
overview of the VOR ICAO channel frequencies, see Table 5-1.
SOURce Subsystem
To Next Page
Loading...
