Remote Control Commands
R&S
®
SMA100B
604User Manual 1178.3834.02 ─ 05
Example: See Example "Setup an LF sweep" on page 599.
Manual operation: See "State (LF frequency sweep)" on page 99
[:SOURce<hw>]:LFOutput:FREQuency:STOP <Stop>
[:SOURce<hw>]:LFOutput:FREQuency:STARt <Start>
Sets the start/stop frequency for [:SOURce<hw>]:LFOutput:FREQuency:MODE
SWEep.
Parameters:
<Start> float
Range: 0.1 Hz to 1 MHz
Increment: 0.1
*RST: 1 KHz
<Stop> float
Range: 0.1 Hz to 1 MHz
Increment: 0.1 Hz
*RST: 100 KHz
Example: See Example "Setup an LF sweep" on page 599.
Manual operation: See " Start Frequency/Stop Frequency " on page 176
[:SOURce]:LFOutput<ch>[:STATe] <State>
Activates LF signal output.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the LF generator" on page 600.
Manual operation: See "State" on page 104
[:SOURce]:LFOutput<ch>:INTernal:VOLTage <Voltage>
Sets the output voltage for the LF generators.
The sum of both values must not exceed the overall output voltage, set with command
[:SOURce]:LFOutput:VOLTage.
Suffix:
<ch>
.
[1]|2
LF1 and LF2
Parameters:
<Voltage> float
Range: 0 to 4
Increment: 0.001
*RST: 1
SOURce Subsystem
To Next Page
Loading...
