Remote Control Commands
R&S
®
SMA100B
665User Manual 1178.3834.02 ─ 05
Usage: Query only
Manual operation: See "Network Status" on page 358
:SYSTem:COMMunicate:NETWork[:COMMon]:DOMain <Domain>
Determines the primary suffix of the network domain.
Parameters:
<Domain> string
Example: See Example "Retrieving information on network-related set-
tings" on page 654.
Manual operation: See "DNS Suffix" on page 360
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname
<Hostname>
Sets an individual hostname for the Signal Generator.
Note:We recommend that you do not change the hostname to avoid problems with the
network connection. If you change the hostname, be sure to use a unique name.
This is a password-protected function. Unlock the protection level 1 to access it, see :
SYSTem:PROTect<ch>[:STATe].
Parameters:
<Hostname> string
Example: See Example "Retrieving information on network-related set-
tings" on page 654.
Manual operation: See "Hostname" on page 359
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup <Workgroup>
Sets an individual workgroup name for the instrument.
Parameters:
<Workgroup> string
Example: See Example "Retrieving information on network-related set-
tings" on page 654.
Manual operation: See "Workgroup" on page 359
:SYSTem:COMMunicate:NETWork[:IPADdress]:DNS <DNS>
Determines or queries the network DNS server to resolve the name.
Parameters:
<DNS> string
Example: See Example "Retrieving information on network-related set-
tings" on page 654.
SYSTem Subsystem
To Next Page
Loading...
