Rohde & Schwarz SMAB-B92 - Page 676

Remote Control Commands
R&S
®
SMA100B
674User Manual 1178.3834.02 ─ 05
Example:
:SYSTem:DATE?
// 2016,05,01
Manual operation: See "Date" on page 690
:SYSTem:NTP:HOSTname <NTPName>
Sets the address of the NTP server. You can enter the IP address, or the hostname of
the time server, or even set up an own vendor zone. See the Internet for more informa-
tion on NTP.
Parameters:
<NTPName> string
Manual operation: See "NTP Address" on page 691
:SYSTem:NTP:STATe
<UseNtpState>
Activates clock synchronization via NTP.
Parameters:
<UseNtpState> 0 | 1 | OFF | ON
*RST: n.a. (factory preset: 0)
Example:
SYSTem:NTP:STATe 1
Manual operation: See "Use Time from NTP Server" on page 691
:SYSTem:TIME <Hour>, <Minute>, <Second>
Queries or sets the time for the instrument-internal clock.
This is a password-protected function. Unlock the protection level 1 to access it, see :
SYSTem:PROTect<ch>[:STATe].
Parameters:
<Hour> integer
Range: 0 to 23
<Minute> integer
Range: 0 to 59
<Second> integer
Range: 0 to 59
Example:
SYSTem:TIME?
// 10,27,14
Manual operation: See "Time" on page 690
SYSTem Subsystem