Rohde & Schwarz SMAB-K24 - Page 130

Avionic Standards
R&S
®
SMA100B
128User Manual 1178.3834.02 ─ 05
2. Select "ILS > General".
This dialog comprises carrier frequency settings related to the ILS glide slope com-
ponent of the ILS signal.
Settings
Carrier Frequency Mode............................................................................................. 128
Carrier Frequency....................................................................................................... 128
ICAO Channel.............................................................................................................129
Sync with Glide Slope/ Sync with Localizer................................................................ 129
EXT AM.......................................................................................................................129
Carrier Frequency Mode
Sets the mode for the carrier frequency of the signal.
"User Defined"
Activates user-defined variation of the carrier frequency.
"ICAO"
Activates variation in predefined steps according to standard ILS
transmitting frequencies (see Table 5-2).
Select the Carrier Frequency Mode to set a standard ILS frequency
channel. If you want to couple carrier frequencies of ILS glide slope
and localizer components, enable Sync with Glide Slope/ Sync with
Localizer.
Remote command:
[:SOURce<hw>]:ILS[:GS|GSLope]:FREQuency:MODE on page 556
Carrier Frequency
Requires "Carrier Frequency Mode > User Defined".
Sets the carrier frequency of the signal.
ILS Configuration and Settings