Improving Level Performance
R&S
®
SMA100B
252User Manual 1178.3834.02 ─ 05
Remote command:
:TRACe[:POWer]:SWEep:MEASurement:STANdard:DISPlay:ANNotation[:
STATe] on page 497
Marker View
Shows the graph and the corresponding marker values at the bottom for frequency
power and level sweep measurement.
Up to four markers can be used to display the current power according to the position
of the marker. The value(s) are displayed at the bottom of the window below the graph.
To move the marker lines you can select them and drag them with your finger. Alterna-
tively you can move them with the rotary knob.
For details on configuring the markers, see "Markers Settings" on page 229.
Remote command:
:TRACe[:POWer]:SWEep:MEASurement:MARKer:DISPlay:ANNotation[:
STATe] on page 497
Gate View
Shows the graph with the corresponding gate data for time trace and pulse data mea-
surements.
Remote command:
:TRACe[:POWer]:SWEep:MEASurement:GATE:DISPlay:ANNotation[:STATe]
on page 496
Pulse Data View
Shows the graph and the corresponding pulse data for time trace and pulse data mea-
surements.
Using Power Sensors
To Next Page
Loading...
