Rohde & Schwarz SMAB-K24 - Setting Security Parameters; Update Policy Security Settings

General Instrument Functions
R&S
®
SMA100B
334User Manual 1178.3834.02 ─ 05
Remote command:
:SYSTem:PROTect<ch>[:STATe] on page 661
11.4.2 Setting Security Parameters
Access:
► Select "System Config > Setup > Security > Security > General".
In the "General" tab, you can determine the security level for firmware updates, and
configure the security settings for the mass memory and manual operation.
All modified settings in this dialog are not applied until you enter the Security Password
and confirm with Accept.
11.4.2.1 Update Policy Security Settings
Access:
► Select "System Config > Setup > Security > Security > General > SW Update".
Using the Security Settings