Rohde & Schwarz SMAB-K24 - Page 459

Remote Control Commands
R&S
®
SMA100B
457User Manual 1178.3834.02 ─ 05
:SENSe[:POWer]:SWEep:POWer:YSCale:MINimum......................................................... 482
:SENSe[:POWer]:SWEep:RMODe...................................................................................483
:SENSe[:POWer]:SWEep:TIME:AVERage[:COUNt]...........................................................483
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:COPY...................................................483
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:POINts?............................................... 484
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:XVALues.............................................. 484
:SENSe[:POWer]:SWEep:TIME:REFerence:DATA:YVALues.............................................. 484
:SENSe[:POWer]:SWEep:TIME:RMODe.......................................................................... 484
:SENSe[:POWer]:SWEep:TIME:SPACing[:MODE].............................................................485
:SENSe[:POWer]:SWEep:TIME:STARt.............................................................................485
:SENSe[:POWer]:SWEep:TIME:STEPs............................................................................485
:SENSe[:POWer]:SWEep:TIME:STOP............................................................................. 485
:SENSe[:POWer]:SWEep:TIME:TEVents..........................................................................486
:SENSe[:POWer]:SWEep:TIME:YSCale:AUTO................................................................. 486
:SENSe[:POWer]:SWEep:TIME:YSCale:AUTO:RESet.......................................................487
:SENSe[:POWer]:SWEep:TIME:YSCale:MAXimum........................................................... 487
:SENSe[:POWer]:SWEep:TIME:YSCale:MINimum............................................................ 487
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:OFFSet <Offset>
Defines the level offset at the sensor input in dB. Activate the offset with the com-
mand :SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:OFFSet:STATe
on page 457.
Parameters:
<Offset> float
Range: -100 to 100
Increment: 0.01
*RST: 0
Example:
SENS2:SWE:FREQ:OFFS -3dB
Defines a level offset of -3 dB.
SENS2:SWE:FREQ:OFFS:STAT ON
Activates the specified level offset.
Options: Option R&S SMAB-K28
Manual operation: See " Level Offset - Power Analysis " on page 240
:SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:OFFSet:STATe <State>
Activates a level offset at the sensor input. Define the appropriate value with the com-
mand :SENSe<ch>[:POWer]:SWEep:FREQuency[:SENSor]:OFFSet
on page 457.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SENS2:SWE:FREQ:OFFS:STAT ON
Activates the specified level offset.
Power Sensor Measurement Subsystems