Rohde & Schwarz SMAB-K24 - Page 518

Remote Control Commands
R&S
®
SMA100B
516User Manual 1178.3834.02 ─ 05
LF1|LF2
Uses an internally generated LF signal.
EXT1|EXT2
Uses an externally supplied LF signal.
NOISe
Uses the internally generated noise signal.
INTernal
Uses the internally generated signal of LF1.
EXTernal
Uses an external LF signal (EXT1).
*RST: LF1 <AM1>; LF2 <AM2>
Example: See Example "Creating an amplitude modulated RF signal"
on page 513.
Manual operation: See "Source" on page 79
[:SOURce<hw>]:AM<ch>[:DEPTh]
<Depth>
Sets the depth of the amplitude modulation in percent.
Suffix:
<ch>
.
1...2
Modulation signal channel
Parameters:
<Depth> float
Range: 0 to 100
Increment: 0.01
*RST: 30
Example: See Example "Creating an amplitude modulated RF signal"
on page 513.
[:SOURce<hw>]:AM<ch>:DEPTh:LINear <DepthLin>
Sets the depth of the linear amplitude modulation in percent / volt.
Parameters:
<DepthLin> float
Range: 0 to 100
Increment: 0.01
*RST: 30
Example: See Example "Creating an amplitude modulated RF signal"
on page 513. Similar to DEPTh.
Manual operation: See "Depth" on page 83
SOURce Subsystem