Rohde & Schwarz SMAB-K24 - Page 568

Remote Control Commands
R&S
®
SMA100B
566User Manual 1178.3834.02 ─ 05
Parameters:
<CarrierFreq> float
Range: 100E3 to 6E9
Increment: 0.01
*RST: 108.1E6
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "Carrier Frequency" on page 135
[:SOURce<hw>]:ILS:LOCalizer:FREQuency:MODE
<IlsLocFreqMode>
Sets the mode for the carrier frequency of the signal.
Parameters:
<IlsLocFreqMode> DECimal | USER | ICAO
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
Manual operation: See "Carrier Frequency Mode" on page 135
[:SOURce<hw>]:ILS:LOCalizer:FREQuency:SYNChronize[:STATe] <Mode>
Activates synchronization of the ILS localizer ICAO channel with the ILS glide slope
ICAO channel.
The ILS glide slope/localizer frequency of the ICAO channel (Table 5-2) is set automat-
ically.
Parameters:
<Mode> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configure and generate an ILS localizer signal"
on page 543.
[:SOURce<hw>]:ILS:LOCalizer:ICAO:CHANnel <SelIcaoChan>
Sets the ICAO channel and the corresponding transmitting frequency.
If avionic standard modulation is activated and you change the "RF Frequency", the
frequency value of the closest ICAO channel is applied automatically. The "ICAO
Channel" is also updated.
The ICAO channel settings for ILS glide slope/localizer components are coupled. For
an overview of the ILS ICAO channel frequencies, see Table 5-2.
SOURce Subsystem