Rohde & Schwarz SMB 100a - Contents Chapter 5 - Remote Control - Basics

R&S SMB Contents "Remote Control - Basics"
1407.0806.32 I-5.1 E-2
Contents Chapter 5 - Remote Control - Basics
5 Remote Control - Basics ....................................................................5.1
Introduction - Remote Control Basics.................................................................. 5.1
Getting Started .................................................................................................... 5.2
Switchover to Remote Control............................................................................. 5.2
Remote Control via IEC/IEEE Bus ......................................................... 5.3
Remote Control via LAN Interface.......................................................... 5.4
Interface and Device Messages.......................................................................... 5.9
Interface Messages................................................................................ 5.9
Device Messages (Commands and Device Responses)....................... 5.9
SCPI Command Structure and Syntax.............................................................. 5.10
Structure of a Command Line .............................................................. 5.13
Responses to Queries.......................................................................... 5.14
Parameters........................................................................................... 5.15
Overview of Syntax Elements .............................................................. 5.17
Instrument Model and Command Processing................................................... 5.18
Input Unit .............................................................................................. 5.18
Command Recognition......................................................................... 5.19
Data Base and Instrument Hardware................................................... 5.19
Status Reporting System...................................................................... 5.20
Output Unit ........................................................................................... 5.20
Command Sequence and Command Synchronization........................ 5.20
Status Reporting System................................................................................... 5.23
Overview of the Status Register........................................................... 5.23
Status Byte (STB) and Service Request Enable Register (SRE) ........ 5.24
IST-Flag and Parallel Poll Enable Register (PPE)............................... 5.24
Event Status Register (ESR) and Event Status Enable Register (ESE)5.25
Application of the Status Reporting System......................................... 5.26
Reset Values of the Status Reporting Systems ................................... 5.28