R&S SMB Command Description
1407.0806.32 6.5 E-2
*SAV
SAVE stores the current device state under the specified number (see also *RCL). The command is
used to store the 3 intermediate instrument states and to store the current instrument state internally
when the instrument is switched off. This state is then restored at power on.
*SRE 0 ... 255
SERVICE REQUEST ENABLE sets the service request enable register to the specified value. Bit 6
(MSS enable bit) remains 0. This command determines the conditions under which a service request
is triggered. The *SRE? query command reads out the content of the service request enable register
in decimal form. Bit 6 is always 0.
*STB?
READ STATUS BYTE QUERY reads out the content of the status byte in decimal form.
*TRG
TRIGGER triggers all actions which are waiting for a trigger event. Specific trigger events can be
triggered by means of the "TRIGger" command system (sweep and lists).
*TST?
SELF TEST QUERY triggers all self tests of the instrument and outputs an error code in decimal
form (see Service Manual supplied with the instrument).
*WAI
WAIT-to-CONTINUE does not allow subsequent commands to be processed until all previous
commands have been executed and all signals are in their transient condition.
To Next Page
Loading...
