Rohde & Schwarz SMB 100a - Page 224

Command Description R&S SMB
1407.0806.32 6.32 E-2
[SOURce:]CORRection:CSET[:SELect] <table name>
The command selects the table for user correction. Level correction must also be activated with the
command SOURce<[1]|2>:CORRection:CSET:STATe ON.
The lists are stored with the fixed file extensions *.uco in a directory of the user's choice. The
directory applicable to the commands is defined with the command MMEMory:CDIR. A path can
also be specified in command :SOUR:CORR:CSET:SEL, in which case the files in the specified
directory are selected.
The command is an event and therefore has no *RST value.
Example:
CORR:CSET ‘var/lists/ucor/ucor1'
'selects the table ucor1.
CORR ON
'activates level correction. Correction is performed using the table ucor1.
*RST value Resolution Options SCPI
- - Device-specific
[SOURce:]CORRection[:STATe] ON | OFF
The command activates/deactivates level correction. Level correction is performed using the table
which has been selected with the command CORRection:CSET:SELect.
Example:
SOUR:CORR:CSET 'ucor1
'selects the table ucor1.
SOUR:CORR ON
'activates user correction.
*RST value Resolution Options SCPI
OFF - Device-specific
[SOURce:]CORRection:VALue?
The command requests the current value for user correction.
This command is a query command and has no *RST value.
Example:
CORR:VAL?
'queries the value currently used for level correction.
Response: -3
'the correction value is - 3dB.
*RST value Resolution Options SCPI
- - Device-specific