Rohde & Schwarz SMBV100A - Page 180

Instrument Function
R&S
®
SMBV100A
165Operating Manual 1176.8016.02 ─ 17
Tip: The name of the dialog is context sensitive and differs depending on the par-
ticular function this dialog is from. However, the provided functions are very similar.
2. To load an existing file, navigate through the file system, select the file and confirm
with "Select".
3. To create a new file, for example if there is no data list file specified, navigate
through the file system to the desired folder, select "New" and specify the file
name.
A new empty file is created and saved in the selected folder.
4. To edit an existing or newly created file, navigate through the file system, select the
file and select "Edit".
The standard "Data List Editor" dialog opens, see "Data List Editor" on page 364.
5. Edit the file content and confirm with "Save".
Directory, File List and File Name
Note:
You access this generic standard function each time you perform one of the following:
●
store or load (settings) files
●
define a folder these files are to be stored in or
●
navigate through the file system.
The name of the dialog is context sensitive but the provided functions are self-explana-
tory and very similar.
With the provided settings, you can perform the following:
●
to navigate through the file system, use the directory tree
●
to create a new file, load and store files, use the dedicated functions "New",
"Select", "Save" and Recent files.
●
to perform standard file management functions, like create new directories, move,
copy, delete files and/or directories, use the standard "File Manager" function (see
" File Manager" on page 162).
Remote command:
to list all files in a directory:
:MMEMory:CDIRectory on page 568
:MMEMory:CATalog? on page 567
refer to the description of firmware options for the syntax of the corresponding SCPI
command:
[:SOURce<hw>]:BB:<Digital Standard>:SETTing:CATalog
[:SOURce]:CORRection:CSET:CATalog? on page 723
to list files with user data:
General Instrument Settings