Instrument Function
R&S
®
SMBV100A
273Operating Manual 1176.8016.02 ─ 17
Parameter Value
Double Pulse Width 100 ns
Double Pulse Delay 200 ns
Pulse Period, Pulse Delay -
Channel 1 = Indicates the external trigger signal. The negative slope is active. A sec-
ond trigger signal during double pulse generation is without effect.
Channel 2 = Indicates the sync signal. The sync signal starts after a trigger delay of
typically 50 ns (see specifications).
Channel 3 = Indicates the double pulse signal. The first pulse starts without a delay.
The second pulse starts after the set double pulse delay (time between
start of first pulse to start of second pulse).
Note: The sync signal is output at the PULSE SYNC connector, and
the double pulse signal at the PULSE VIDEO connector.
RF Block
To Next Page
Loading...
