Rohde & Schwarz SMBV100A - Page 388

Instrument Function
R&S
®
SMBV100A
373Operating Manual 1176.8016.02 ─ 17
"Armed_Ret-
rigger"
The digital modulation signal is generated only when a trigger event
occurs. Then the signal is generated continuously. Every subsequent
trigger event (internal with "Execute Trigger" or external) causes a
restart.
The button "Arm" stops signal generation. A subsequent trigger event
(internal with "Execute Trigger" or external) causes a restart.
"Single"
The digital modulation signal is generated only when a trigger event
occurs. Then the signal is generated once to the length specified at
"Signal Duration". Every subsequent trigger event (internal with "Exe-
cute Trigger" or external) causes a restart.
Remote command:
[:SOURce<hw>]:BB:DM[:TRIGger]:SEQuence on page 661
Trigger Signal Duration
Enters the length of the signal sequence to be output in the "Single" trigger mode. The
input is to be expressed in symbols.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:SLENgth on page 658
Running - Stopped
Displays the status of signal generation for all trigger modes. This display appears only
when Custom Dig Mod is enabled (State On).
"Running"
The digital modulation signal is generated; a trigger was (internally or
externally) initiated in triggered mode.
If Armed_Auto and Armed_Retrigger have been selected, generation
of signals can be stopped with the "Arm" button. A new trigger (inter-
nally with "Execute Trigger" or externally) causes a restart.
"Stopped"
The signal is not generated, and the instrument waits for a trigger
event (internal or external).
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:RMODe? on page 657
Arm
Stops signal generation. This button appears only with "Running" signal generation in
the "Armed_Auto" and "Armed_Retrigger" trigger modes.
Signal generation can be restarted by a new trigger (internally with "Execute Trigger"
or externally).
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:ARM:EXECute on page 655
Execute Trigger
Executes trigger manually. A manual trigger can be executed only when an internal
trigger source and a trigger mode other than "Auto" have been selected.
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:EXECute on page 655
Baseband Signal - Baseband Block