Instrument Function
R&S
®
SMBV100A
395Operating Manual 1176.8016.02 ─ 17
Switching between the segments is triggerd by changing the segment index in the
"Next Segment" field.
●
When "Next Segment" is selected, the current segment ceases to be output as
soon as a trigger event for a new segment occurs, and the new segment starts to
be output after a system-imposed signal gap.
The following figure shows an example of the transition from a sinewave signal
segment to a sawtooth segment (I channel, above) in the case of next segment
external triggering (below).
●
When "Next Segment" Seamless is selected and a new segment trigger event
occurs, the new segment is not output until the whole of the current segment has
been output (wrap around). In this case the signal transition is seamless. As a pre-
requisite for a seamless switchover, all segments must have the same sample rate.
The following figure shows an example of the seamless transition from a sinewave
signal segment to a sawtooth segment (I channel, above) in the case of next seg-
ment external triggering (below).
Baseband Signal - Baseband Block
To Next Page
Loading...
