Instrument Function
R&S
®
SMBV100A
417Operating Manual 1176.8016.02 ─ 17
"Marker
1/2/3/4"
Generates a restart marker signal at the beginning of the first seg-
ment for the corresponding marker.
Use this setting to generate a restart marker for the complete
sequence.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:FSEGment
on page 642
Segment Restart
Enables/disables the generation of an additional marker restart signal in the output
waveform file.
If additional marker generation is enabled, the existing marker signals in the individual
segment waveform files are not considered.
"Disable"
No additional marker is generated.
"Marker
1/2/3/4"
Generates a restart marker signal at the beginning of each segment
for the corresponding marker.
The segment begin is defined by the low-high slope of the marker.
This applies for switching between two segments as well as in case
of segment replay.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:MARKer:ESEGment
on page 642
Output File
In the Output File section, the output file name is specified and a comment can be
added to the file.
Comment
Adds a comment to the multi segment file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:COMMent on page 641
Output file
Opens the File menu, where the file name of the multi segment waveform which has to
be calculated can be entered. The multi segment waveform is saved under this name
by clicking the "Create" or "Create and Load" button.
A name must also be entered here before the list can be saved as a configuration file
("Save List"). In this case the name is needed for internal storage procedures. It is
entered as the default name for the multi segment waveform file when loading the list.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe on page 643
Handling of Multi Segment Files
The buttons in this sections are provided for handling of the multi segment files.
Baseband Signal - Baseband Block
To Next Page
Loading...
