Instrument Function
R&S
®
SMBV100A
438Operating Manual 1176.8016.02 ─ 17
General Settings for Multi Carrier CW
The upper part of the menu is used for powering up the Multi Carrier CW signal and
calling the default settings.
State
Enables/disables the Multi Carrier CW.
Switching on this standard turns off all the other digital standards and digital modula-
tion modes.
Since Multi Carrier CW signals are computed in arbitrary waveform mode, changes to
the settings of individual carriers are not adopted until the Accept button is pressed.
This applies to the settings in the "Table Setup Assistant" section and the "Carrier
Table" dialog.
Remote command:
[:SOURce<hw>]:BB:MCCW:STATe on page 693
Set to Default
Calls default settings. The values are shown in the following table.
Parameter Value
State Not affected by "Set to Default"
Carrier Setup
Number of Carriers 64
Carrier Spacing 10 kHz
Optimize Crest Factor Chirp
Desired Crest Factor 3 dB
Trigger
Mode Auto
Source Internal
Ext. Delay 0
Ext. Inhibit 0
Marker
Channel 1...4 Restart
Clock
Source Internal
Multi Channel Setup
Start Carrier 0
Stop Carrier 0
State ON
Power 0 dB
Baseband Signal - Baseband Block
To Next Page
Loading...
