Instrument Function
R&S
®
SMBV100A
441Operating Manual 1176.8016.02 ─ 17
Carrier Stop
Defines the stop index of the carrier range to which the following settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP on page 702
Carrier State
Switches the carriers in the carrier range on/off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe on page 702
Power Start
Sets the power of the starting carrier.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt] on page 702
Power Step
Sets the width of the step with which the power will be changed from carrier to carrier.
The carrier power that is set with Power + n* Power Step must be within the valid
value range -80 dB to 0 dB.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP on page 701
Phase Start
Sets the phase of the starting carrier. This setting is only available for "Optimize Crest
Factor Mode" = Off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt] on page 701
Phase Step
Sets the width of the step with which the phase will be changed from carrier to carrier.
The phase that is set with Phase + n* Phase Step must be within the valid value range
0° to 360°.
This setting is only available for "Optimize Crest Factor Mode" = Off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP on page 700
Accept
Adopts the carrier range setting into the table ("Carrier Table").
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute on page 700
Carrier Table and Carrier Graph
The lower part of the menu is used to open submenus for configuring carrier tables and
for setting triggers, markers and clocks.
Baseband Signal - Baseband Block
To Next Page
Loading...
