Rohde & Schwarz SMBV100A - Hcopy:file[:Name]:Auto[:File]:Number; Hcopy:file[:Name]:Auto[:File]:Prefix; Hcopy:file[:Name]:Auto[:File]:Prefix:state

Remote Control Commands
R&S
®
SMBV100A
560Operating Manual 1176.8016.02 ─ 17
Example: See Example "Store a hard copy of the display" on page 556.
Manual operation: See " File Options " on page 157
:HCOPy:FILE[:NAME]:AUTO[:FILE]:NUMBer?
Queries the number that is used as part of the file name for the next hard copy in auto-
matic mode.
At the beginning, the count starts at 0. The R&S SMBV searches the specified output
directory for the highest number in the stored files. It increases this number by one to
achieve a unique name for the new file.
The resulting auto number is appended to the resulting file name with at least three
digits.
Return values:
<Number> integer
Range: 0 to 999999
*RST: 0
Example: See Example "Store a hard copy of the display" on page 556.
Usage: Query only
Manual operation: See " File Options " on page 157
:HCOPy:FILE[:NAME]:AUTO[:FILE]:PREFix <Prefix>
Defines the prefix part in the automatic file name. The usage of the prefix is activated
with command HCOP:FILE:AUTO:PREF:STAT 1
Parameters:
<Prefix> string
Example: See Example "Store a hard copy of the display" on page 556.
Manual operation: See " File Options " on page 157
:HCOPy:FILE[:NAME]:AUTO[:FILE]:PREFix:STATe <State>
Uses the prefix for the generation of the automatic filename, provided Automatic Nam-
ing is activated.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example: See Example "Store a hard copy of the display" on page 556.
Manual operation: See " File Options " on page 157
HCOPy Subsystem