Rohde & Schwarz SMBV100A - Page 620

Remote Control Commands
R&S
®
SMBV100A
605Operating Manual 1176.8016.02 ─ 17
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal<1|2>]:RDELay?.................................... 609
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal<1|2>]:INHibit........................................ 610
[:SOURce<hw>]:BB:ARBitrary[:TRIGger]:SEQuence......................................................... 610
[:SOURce<hw>]:BB:ARBitrary:TRIGger:ARM:EXECute
The command stops waveform output for trigger modes Armed_Auto and Armed_Ret-
rigger. A subsequent internal or external trigger event restart waveform output.
Example:
BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:TRIG:SEQ ARET
sets Armed_Retrigger mode, i.e. every trigger event causes
waveform output to restart.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started.
BB:ARB:TRIG:ARM:EXEC
waveform output is stopped.
BB:ARB:TRIG:EXEC
executes a trigger, waveform output is started again.
Usage: Event
Manual operation: See "Arm" on page 391
[:SOURce<hw>]:BB:ARBitrary:TRIGger:EXECute
The command executes a trigger. The internal trigger source must be selected using
the command ARB:TRIGger:SOURce INTernal and a trigger mode other than
AUTO must be selected using the command :ARB:SEQuence.
Example:
BB:ARB:TRIG:SOUR INT
sets internal triggering.
BB:ARB:SEQ RETR
sets Retrigger mode, i.e. every trigger event causes signal out-
put to restart.
BB:ARB:TRIG:EXEC
executes a trigger.
Usage: Event
Manual operation: See "Execute Trigger" on page 388
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:SYNChronize:OUTPut
<Output>
(enabled for "Trigger Source" External)
Enables/disables output of the signal synchronous to the external trigger event.
SOURce Subsystem