Rohde & Schwarz SMBV100A - Marker Settings

Remote Control Commands
R&S
®
SMBV100A
611Operating Manual 1176.8016.02 ─ 17
Parameters:
<Sequence> AUTO | RETRigger | AAUTo | ARETrigger | SINGle
AUTO
The waveform is output continuously.
RETRigger
The waveform is output continuously. A trigger event (internal or
external) causes a restart.
AAUTo
The waveform is output only when a trigger event occurs. After
the trigger event the waveform is output continuously. Waveform
output is stopped with command
SOUR:BB:ARB:TRIG:ARM:EXEC and started again when a trig-
ger event occurs.
ARETrigger
The waveform is output only when a trigger event occurs. The
device automatically toggles to RETRIG mode. Every subse-
quent trigger event causes a restart. Waveform output is stop-
ped with command SOUR:BB:ARB:TRIG:ARM:EXEC and star-
ted again when a trigger event occurs.
SINGle
The waveform is output only when a trigger event occurs. After
the trigger event the waveform is output once to the set
sequence length (SOUR:BB:ARB:TRIG:SLEN). Every subse-
quent trigger event causes a restart.
*RST:
AUTO
Example:
BB:ARB:SEQ AAUT
sets the "Armed_auto" trigger mode; the device waits for the first
trigger (e.g. with *TRG) and then generates the signal continu-
ously.
Manual operation: See "Trigger Mode" on page 390
Marker Settings
The TRIGger:OUTPut subsystem contains the commands for setting the marker.
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:MODE............................................. 611
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:OFFTime......................................... 612
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:ONTime...........................................612
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PATTern..........................................613
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:DIVider.................................613
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:PULSe:FREQuency?........................ 613
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut:DELay:FIXed...........................................614
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay............................................. 614
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:MODE <Mode>
The command defines the signal for the selected marker output.
SOURce Subsystem