Rohde & Schwarz SMBV100A - Page 646

Remote Control Commands
R&S
®
SMBV100A
631Operating Manual 1176.8016.02 ─ 17
Manual operation: See "File Size" on page 431
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:CATalog?
Queries the available settings files in the specified default directory. The settings files
are used to set the ARB multi carrier submenu. Only files with the file extension
*.arb_multcarr will be listed.
Return values:
<Catalog> string
Example:
MMEM:CDIR '/var/user/waveform'
sets the default directory
BB:ARB:MCAR:SETT:CAT?
reads out all the settings files in the default directory.
Response: mcar1, mcar2
the directory contains the configuration files
mcar1.arb_multcarr and mcar2.arb_multcarr.
Usage: Query only
Manual operation: See "Save/Recall Frame" on page 425
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:LOAD <Filename>
Loads the settings file. If a settings file with the specified name does not yet exist, it is
created. The file extension may be omitted. Only files with the file extension
*.arb_multcarr will be loaded or created.
Setting parameters:
<Filename> string
Example:
BB:ARB:MCAR:SETT:LOAD '/var/user/new'
creates settings file new.arb_multcarr.
Usage: Setting only
Manual operation: See "Save/Recall Frame" on page 425
[:SOURce<hw>]:BB:ARBitrary:MCARrier:SETTing:STORe <Filename>
The command stores the current settings of submenu "Multi Carrier" in a file in the
specified directory. The file extension may be omitted, the files are stored with the file
extension *.arb_multcarr.
Setting parameters:
<Filename> string
Example:
BB:ARB:MCAR:SETT:STOR '/var/user/mcarr2'
stores settings file mcarr2.arb_multcarr in the default direc-
tory.
Usage: Setting only
SOURce Subsystem