Rohde & Schwarz SMBV100A - [:Source<Hw>]:Bb:arbitrary:wsegment:configure:comment; [:Source<Hw>]:Bb:arbitrary:wsegment:configure:delete; [:Source<Hw>]:Bb:arbitrary:wsegment:configure:level[:Mode]

Remote Control Commands
R&S
®
SMBV100A
641Operating Manual 1176.8016.02 ─ 17
Parameters:
<Mode> UNCHanged | HIGHest | USER
UNCHanged
The segments are output with the clock rate defined in the wave-
form file.
HIGHest
The segments are output at the highest available clock rate.
USER
The segments are output with the clock rate defined with com-
mand [:SOURce<hw>]:BB:ARBitrary:WSEGment:
CONFigure:CLOCk
*RST: UNCHanged
Example:
BB:ARB:WSEG:CONF:CLOC:MODE UNCH
selects clock mode unchanged. The segments are output with
the clock rate defined in the waveform file.
Manual operation: See " Clock " on page 416
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:COMMent <Comment>
This command enters a comment for the configuration file. The configuration file must
be specified with command :BB:ARB:WSEG:CONF:SEL.
Parameters:
<Comment> string
Example:
BB:ARB:WSEG:CONF:COMM <3gpp_up>
enters comment "3gpp_up".
Manual operation: See " Comment " on page 417
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:DELete <Filename>
Deletes the configuration file. The configuration files are used to create multi segment
waveform files.
Setting parameters:
<Filename> string
Example:
MMEM:CDIR '/var/user/waveform'
sets the default directory.
BB:ARB:WSEG:CONF:DEL 'multi1'
deletes configuration file multi1.inf_mswv.
Usage: Setting only
Manual operation: See " Delete " on page 414
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:LEVel[:MODE] <Mode>
This command selects the level mode for the multi segment waveform.
SOURce Subsystem