Rohde & Schwarz SMBV100A - Page 708

Remote Control Commands
R&S
®
SMBV100A
693Operating Manual 1176.8016.02 ─ 17
Suffixes
SOURce<hw>
For one-path instruments, the keyword SOURce is optional and can be omitted.
The numeric suffix to SOURce distinguishes between signal generation for path A and
path B in the case of two-path instruments:
●
SOURce[1] = path A
The keyword SOURce is optional and can be omitted
●
SOURce2 = path B
The keyword SOURce is mandatory, i.e. the command must contain the keyword
with suffix 2.
OUTPut<ch>
The numeric suffix to OUTPut distinguishes between the available markers.
Only two markers are available for the R&S SMBV, i.e. the allowed values for the suffix
are 1 or 2.
General Settings and Carrier Setup Settings
[:SOURce<hw>]:BB:MCCW:STATe................................................................................. 693
[:SOURce<hw>]:BB:MCCW:PRESet................................................................................694
[:SOURce<hw>]:BB:MCCW:CARRier:COUNt................................................................... 694
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe........................................................... 694
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer........................................................... 695
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe............................................................696
[:SOURce<hw>]:BB:MCCW:CARRier:PHASe................................................................... 696
[:SOURce<hw>]:BB:MCCW:CARRier:POWer................................................................... 697
[:SOURce<hw>]:BB:MCCW:CARRier:SPACing.................................................................697
[:SOURce<hw>]:BB:MCCW:CARRier:STATe....................................................................698
[:SOURce<hw>]:BB:MCCW:CFACtor...............................................................................698
[:SOURce<hw>]:BB:MCCW:CFACtor:ACTual?................................................................. 698
[:SOURce<hw>]:BB:MCCW:CFACtor:MODE.................................................................... 699
[:SOURce<hw>]:BB:MCCW:CLOCk?...............................................................................699
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute........................................................ 700
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP................................................. 700
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt]...............................................701
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP................................................. 701
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt]...............................................702
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt............................................................702
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe........................................................... 702
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP.............................................................702
[:SOURce<hw>]:BB:MCCW:STATe <State>
Activates the multi carrier CW signal generation and deactivates all the other digital
standards and digital modulation modes in the same path.
SOURce Subsystem