Remote Control Commands
R&S
®
SMBV100A
698Operating Manual 1176.8016.02 ─ 17
Example:
BB:MCCW:CARR:SPAC 10 MHz
sets a carrier spacing of 10 MHz.
Manual operation: See "Carrier Spacing" on page 439
[:SOURce<hw>]:BB:MCCW:CARRier:STATe <CarrierIndex>, <State>
Switches the selected carrier on or off.
The counting in remote control differs from the numbers in the carrier table. Index 0
corresponds to number 1 (first line) in the table. Therefore, switching the state of the
channel via remote control always switches the state of <channel index> + 1 in the
table.
Parameters:
<CarrierIndex> integer
Range: 0 to lastCarrier
<State> select
*RST: 0
Example:
BB:MCCW:CARR:STAT 15, ON
switches carrier 16 on.
Manual operation: See "Carrier Table" on page 442
[:SOURce<hw>]:BB:MCCW:CFACtor <CFactor>
Sets the desired crest factor for the multi carrier signal on selection of the command
SOUR:BB:MCCW:CFAC:MODE SLOW.
Parameters:
<CFactor> float
Range: 0 to 30
Increment: 0.01
*RST: 3
Example:
BB:MCCW:CFAC:MODE SLOW
sets the Target Crest optimization mode.
BB:MCCW:CFAC 10 dB
sets the desired crest factor to 10 dB.
Manual operation: See "Desired Crest Factor" on page 440
[:SOURce<hw>]:BB:MCCW:CFACtor:ACTual?
Queries the actual Crest Factor for BB:MCCW:CFAC:MODE SLOW.
SOURce Subsystem
To Next Page
Loading...
