Remote Control Commands
R&S
®
SMBV100A
712Operating Manual 1176.8016.02 ─ 17
Parameters:
<Pattern> numeric
0 is marker off, 1 is marker on.
*RST: #H2
<BitCount> integer
Range: 1 to 64
*RST: 2
Example:
BB:MCCW:TRIG:OUTP2:MODE PATT
BB:MCCW:TRIG:OUTP2:PATT #HE0F52,20
Manual operation: See "Marker Mode" on page 448
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:DIVider
<Divider>
Sets the divider for Pulse marker mode (SOUR:BB:MCCW:TRIG:OUTP:MODE PULSe).
The resulting pulse frequency is derived by dividing the symbol rate by the divider.
Parameters:
<Divider> integer
Range: 2 to 1024
*RST: 2
Example:
BB:MCCW:TRIG:OUTP2:PULS:DIV 2
sets the divider for the marker signal on output MARKER 2 to
the value 2.
BB:MCCW:TRIG:OUTP2:FREQ?
queries the resulting pulse frequency of the marker signal
Response: 66 000
the resulting pulse frequency is 66 kHz.
Manual operation: See "Marker Mode" on page 448
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal in the setting
SOUR:BB:MCCW:TRIG:OUTP:MODE PULS. The pulse frequency is derived by dividing
the symbol rate by the divider. The divider is defined with command
SOUR:BB:MCCW:TRIG:OUTP:PULS:DIV.
Return values:
<Frequency> float
Increment: 1E-3
SOURce Subsystem
To Next Page
Loading...
