Remote Control Commands
R&S
®
SMBV100A
777Operating Manual 1176.8016.02 ─ 17
Example: see [:SOURce<hw>]:LIST:INDex:STARt on page 776
Manual operation: See " List Range In - List Mode " on page 293
[:SOURce<hw>]:LIST:LEARn
Learns the selected list to determine the hardware setting for all list entries. The results
are saved with the list. When the list is activated the first time, these settings are calcu-
lated automatically.
Example:
LIST:SEL '/var/user/list3'
selects list file. The file is created if it does not yet exist.
LIST:LEAR
starts learning of the hardware setting for list3 and stores the
setting.
Usage: Event
Manual operation: See " Learn List Mode Data... - List Mode " on page 291
[:SOURce<hw>]:LIST:MODE <Mode>
Selects how the list is to be processed (similar to SOURce:SWEep:MODE).
Parameters:
<Mode> AUTO | STEP
AUTO
Each trigger event triggers a complete list cycle. Possible trigger
settings for :LIST:TRIGger:SOURce are AUTO, SINGle and
EXT.
STEP
Each trigger event triggers only one step in the list processing
cycle. The list is processed in ascending order.
Possible trigger settings for :LIST:TRIGger:SOURce are
SINGle and EXT
*RST: AUTO
Example:
LIST:MODE STEP
selects step-by-step processing of the list.
Manual operation: See "Mode - List Mode" on page 290
[:SOURce<hw>]:LIST:POWer <Power>
Fills the Level part of the selected list with data.
*RST does not affect data lists.
SOURce Subsystem
To Next Page
Loading...
