Rohde & Schwarz SMBV100B - Page 15

Contents
R&S
®
SMBV100B
13User Manual 1178.4460.02 ─ 03
8.4.1.1 Prerequisites for Control of External Instruments from the R&S SMBV100B............. 436
8.4.1.2 Test Setups................................................................................................................. 436
8.4.1.3 Control of Connected External Instruments................................................................ 436
8.4.1.4 Overview of the Input and Output Signals and Interfaces...........................................436
Overview of the Baseband Signal Sources.................................................................437
Overview of the RF Output Signals.............................................................................437
Important Signal Parameters and Interface's Characteristics..................................... 438
8.4.1.5 Further Information......................................................................................................442
8.5 System Configuration Settings................................................................................442
8.5.1 I/Q Stream Mapper Settings........................................................................................443
8.5.2 External RF and I/Q Settings...................................................................................... 443
8.5.2.1 Connections Configuration and Connection Status Overview Settings...................... 445
8.5.2.2 External Instrument Configuration Settings.................................................................449
Remote Config Settings.............................................................................................. 450
Remote Control Settings............................................................................................. 453
Show Connector..........................................................................................................454
8.5.3 Overview..................................................................................................................... 455
8.6 Digital Baseband Input Settings.............................................................................. 455
8.6.1 General Settings......................................................................................................... 457
8.6.2 Signal Input Settings................................................................................................... 459
8.6.3 Sample Rate Settings................................................................................................. 462
8.6.4 Input Level Settings.....................................................................................................463
8.7 I/Q Analog Output Settings...................................................................................... 464
8.7.1 General Analog I/Q Output Settings............................................................................466
9 File and Data Management................................................................471
9.1 About the File System.............................................................................................. 471
9.2 Restoring the (Default) Instrument Configuration................................................. 474
9.2.1 Preset, Set to Default and Factory Preset Settings.....................................................476
9.2.2 How to Identify Parameters Which Are Not in a Preset State..................................... 477
9.2.3 How to Recall User Settings Automatically after Preset............................................. 478
9.2.4 Reference....................................................................................................................478
9.3 Protecting Data..........................................................................................................480
9.4 Saving and Recalling Instrument Settings............................................................. 480